Video answer: Rv water heater not igniting or staying lit
Top best answers to the question «Rv hot water heater not working on gas»
One of the most common problems with Atwood RV water heater is a pilot outage. This can happen if you have a weak gas control magnet or if the thermocouple needs to be replaced. For poor pilot flame, you would need to replace the orifice. If it is not too old hen you can try cleaning the orifice and see how it goes.
Video answer: How to troubleshoot a rv hot water heater that will not ignite
7 other answers
If your gas water heater recovers too slowly, the thermostat could be set too low, the burner assembly may need to be cleaned, the propane gas pressure may be too low, or the vent flue may need to be cleaned. But in most cases, it’s just using water faster than the water heater can heat water. RV Water Heater Won’t Light
When conducting your RV water heater troubleshooting steps for this unit, you will want to locate the control panel. Look for the DCI lights on the panel. If they are lit, you will need to go outside and push the reset buttons on the water heater. If this does not fix the issue, additional RV water heater troubleshooting will be needed.
Start by verifying the problem is not an issue with supply. Here is what you will need to check: Pressurized freshwater is reaching the inlet of the water heater. This is most easily tested by opening the pressure relief valve located near the top of the water heater. If water comes out, it is not a supply problem.
Maintain your RV water heater with regular servicing. Turn off power to your water heater. Make sure both the gas and electric switches are in the OFF position, and wait a while for water to cool down. Find the water heater bypass valve, usually located inside the RV behind the heater.
Turn off the hot water heater and let it cool off. Drain and flush the tank. Flushing the tank first will get rid of any loose sediment. Use household bleach to sanitize the tank.
Water heater will not light on gas nor electric. The gas. the gas burner will not light. this is a new camper, the burner light, heated the water then shut off, bur would not reignite, I checked the 2 amp fuse it is … read more.
However, this is a sign that you have your water heater temperature set too high. Reduce the temperature settings on your water heater and this should correct the problem. If it continues to leak, then I would suggest you properly replace the valve, and this should solve your problem.