How do i restart my gas fireplace?

5
Hobart Paucek asked a question: How do i restart my gas fireplace?
Asked By: Hobart Paucek
Date created: Wed, Apr 14, 2021 6:14 AM
Date updated: Sun, Jul 3, 2022 6:00 PM

Content

Video answer: How to light a gas fireplace

How to light a gas fireplace

Top best answers to the question «How do i restart my gas fireplace»

Turn the knob from the “Off” to the “Pilot” position. Push in the pilot knob, which manually sends gas into the system. Push the igniter button once every second until it lights. Depending on how long it's been since the gas fireplace was last used, ignition may take multiple attempts.

Video answer: How to start a gas fireplace

How to start a gas fireplace

4 other answers

The following are the steps to take your fireplace out of "lock out" mode: If your fireplace has a black reset button, push the button. If your fireplace does not have a reset button, unplug the white molex connector from the module located at the bottom of the fireplace to the right of the valve, wait 60 seconds and plug it back in.

Look for a knob on your control panel with the words On, Off, and Pilot on it. If the knob is not in the off position, turn it so that it is. Then, let your fireplace sit for at least 5 minutes, allowing any excess or lingering gas to clear out.

With a sharp object, press and hold the receiver's reset button until you hear one short and one long beeps. Release the reset button after the second beep. 3. Within the subsequent 20 seconds, press the small . Is it OK to leave pilot light on gas fireplace? Leaving the gas on keeps this compound moving out of

How do I reset my electric fireplace remote? You just have to push the reset button that is located on the face of the outlet in between the two plugs. If your electric fireplace is plugged into an outlet that is controlled by a wall switch, make sure the wall switch is flipped to the ON position.

Your Answer

Video answer: My gas fireplace won't light: resetting the control module

My gas fireplace won't light: resetting the control module