Video answer: Weedeater fuel line replacement
Top best answers to the question «How big is a weed eater gas tank»
The capacity of that model is 0.41 quarts. I recommend mixing the fuel a 1/2 quart at a time in an approved container. Do not mix the fuel in the tank of the trimmer. If it not mixed enough, it could cause damage to the engine.
Video answer: Weed eater edger gas tank replacement #580236101
10 other answers
A weed eater can be an essential tool for maintaining a neat and attractive garden. However, if your weed eater isn't working properly, it could be an issue with the gas tank. Checking to see if its dirty or damaged an be done at home, as can replacing a worn out gas tank with a new one.
Since weed wackers have small gas tanks, a 1 US gal (3.8 L) can should be plenty. 1 US gal (3.8 L) is also a good amount because in the US, mixing oil usually comes in small bottles measured to a 50:1 mixture for a gallon of gas. This way, you can just pour in the whole bottle, unless you're using a different ratio.
Weed Eater Gas Tank Replacement. Weed Eater Gas Tank Replacement 10 out of 10 based on 63 ratings. I currently have a Weed Eater WT3100 that runs briefly when cranked the stutters and dies as if it was sarved for fuel. To date I have replaced the … What is the Fuel-Oil mix ratio? The fuel-oil mixture ratio for all Weed Eater products is 40:1. You can obtain this ratio by mixing 3.2 oz. of ...
The fuel-oil mixture ratio for all Weed Eater products is 40:1. You can obtain this ratio by mixing 3.2 oz. of two cycle air cooled engine oil with one gallon of regular gas. Over a period of time oil will separate from gasoline. To properly insure oil and gas mixture, we recommend thoroughly shaking your oil and gas mixture before refueling your unit.
Weed Eater 581263701 Fuel Tank Assembly. Visit the Weed Eater Store. 4.7 out of 5 stars. 245 ratings. Price: $16.20 Get Fast, Free Shipping with Amazon Prime & FREE Returns. Return this item for free. Free returns are available for the shipping address you chose.
Now you need about 3" of small fuel line which will go from the top connector of the carb to the small inlet connector on the primer bulb base. Now that thick line from the tank is connected to the big connector on the primer bulb base. The thick line inside the tank should have a breather nipple attached to it. This line should be about 1/4" to 1" below the fuel cap hole. This is a breather valve so you dont want it submerged in fuel when priming the carb.
Weed Eater gas trimmer would not keep running and hard to start, leaked fuel were gas lines enter tank. I replaced the gas tank which came with gas lines and filter . Took 20 minutes for the job Filled tank with new mix of gas, primed and started on first pull. Trimmer is running very well. Did not have to rebuild carburetor Job was easy, took out 5 allen bolts and removed rear cover which the ...
I will show you how to easily fix a hole or crack in a plastic gas tank. This will work for lawn mowers, tractors, or any small engine machine that has a pla...
When things get hot the gas begins to leak out of this connection - where the fuel line goes inside the tank. The fuel line I use is the yellow transparent line 3/16 OD x 3/32 ID. Any ideas on how I can fix this?
Is your plastic fuel tank cracked, leaking or punctured? You have two options, replace it or repair it. Why not try to fix it first? Over time, through regu...